Mullvad socks511/1/2023 ![]() ![]() # Make sure we also allow SSH (duhh, so we don't get locked out) and Wireguard to pass through # Install ufw "Uncomplicated Firewall" (it's better than fail2ban, don't install fail2ban) > # Then run the backup after each fill stage has been completed or you risk having to do everything all over from the beginning > # Configure your backup location to an EMPTY directory on a SEPARATE USB formatted as > **ext4** > using the above command > NB! To back up everything (and not have to do all the below s* again) run this after each steps success You can run this command later with a > 1 > at the end to quickly run the backup with your last used config** Remove any unneeded/unused packages apt autoremove Upgrade any packages that have updates apt upgrade > You have been warned! After RPi 4 Dietpi first installation, you can now follow these steps: Update repositories apt update ![]() Saving backups to the Micro SD or External HDD is NOT a good idea. > ext2fsd > but then make sure to NEVER write files to the USB from Windows or you risk serious issues! (Reading and copying FROM is okay). ![]() NB! Keep a SEPARATE USB of at least 4GB in size which will be used for backups and which will be formatted as > ext4 > which will be > UNREADABLE > in Windows unless you use e.g. Recommended to use Ethernet for better performance and speeds and for external storage use at the very least a USB 3.0 HDD or USB-SSD. Pre-guide (before install): Port Forward the Port we will be using for Wireguard in our router (Port: 51820) Set up your Raspberry Pi 4 following the guide with default settings (or at least know what you are doing when you set it up) and disable IPv6 because it’s stupid. You’ll need to replace anything in with your own specific requirements/file names/et cetera. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |